HI! I don't know if I accidentally messed up a setting or two while experimenting with Fluxbox late last night.
But this morning when I started antiX in Fluxbox, about the bottom quarter of the Conky display won't show.
It's fine in IceWM and JWM, though.
Any ideas as to what might cause that?
And/or is there an easy-peasy way to reset Fluxbox to its default settings?
I'm pretty sure I accidentally messed up a setting or two with Fluxbox while not paying attention.
I therefore have no idea what I made an 'oopsies' on.
Thanks in advance.
4 posts
• Page 1 of 1
-
Posts: 75
- Joined: 11 Jul 2011
-
Posts: 75
- Joined: 11 Jul 2011
#2
Oh dear!
I switched back to Fluxbox and Conky was showing properly.
Unfortunately, my laptop seized up and didn't respond to any input immediately after that, and I had to reboot it.
I hope that's just a one off.
But I'd still like to know if there's a quick way to resetting Fluxbox to default settings.
Doesn't hurt to know things like that.
I switched back to Fluxbox and Conky was showing properly.
Unfortunately, my laptop seized up and didn't respond to any input immediately after that, and I had to reboot it.
I hope that's just a one off.
But I'd still like to know if there's a quick way to resetting Fluxbox to default settings.
Doesn't hurt to know things like that.
-
Posts: 1,445
- Joined: 09 Feb 2012
#3
Yes, you can quickly"reset to defaults" your conky configuration.
from terminal emulator commandline:
mv ~/.conkyrc ~/.conkyrc_OLD
cp /etc/skel/.conkyrc ~/.conkyrc
from terminal emulator commandline:
mv ~/.conkyrc ~/.conkyrc_OLD
cp /etc/skel/.conkyrc ~/.conkyrc
-
Posts: 75
- Joined: 11 Jul 2011
#4
Thanks!